Follow Me

Close

172A• Break pressure manholes

In some installations with a steep and long slope in which water goes down from a deposit, spring, etc. it is necessary to break the growing pressure which is produced in the parte inferior of the pipe with the aim of not having excessive pressure in the case that the pipe transfers the load or suffers some obstruction.Leer más

167a

Background

From 1993 to 2004, when it was enacted the European normative EN 12201:2003, the PE 80 and PE 100 pipes were manufactured with some TECHNICAL SPECIFICATIONS whose content was exactly equal to the project of European normative prEN 12201. The Certification of AENOR in basis of the corresponding PARTICULAR REGULATION RP01.35 for PE 100 pipes and RP01.41 fr the PE 80 pipes, gives place to a CERTIFICATE OF CONFORMITY, whose nº was marked in the pipe and identified the manufacturer. Since 2003 these pipes have been manufactured with the Brand “N” of AENOR. These pipes were designed with a safety coefficient C = 1.25, in fact the compound PE 100 which was born at the beginning of the 1990 and was used to manufacture PE 100 pipes with a coefficient C = 1.25.Leer más

166a

Background

The Subcommittee of normalization of AENOR SC2 “Plastic pipes and fittings” whose Secretary’s office is masterfully run by Mª Carmen del Amo of ANAIP, which depends on the Technical Committee of Normalization CTN 53 “Plastics and Rubber” of AENOR, whose Secretary’s office runs the entities ANAIP and COFACO.Leer más

165a

drenotube® is a drainage perform which substitutes the classic drainage system. It is composed of 4 elements:

Grooved pipe – corrugated of doubled wall HDPE for the water conduction and evacuation. For the connection of the modulus it is included sockets of quick plugging. The external and internal diameter of the pipe is 110 mm and 90 mm, respectively.Leer más